Hello,
When I open Terminal, I don't get a chance to enter any commands. When I first open it, it pauses for 2-3 seconds then displays:
login(1952) malloc: *** mmap(size=2931998720) failed (error code=12)
*** error: can't allocate region
*** set a breakpoint in malloc_error_break to...
Hello,
When I open Terminal, I don't get a chance to enter any commands. When I first open it, it pauses for 2-3 seconds then displays:
login(1952) malloc: *** mmap(size=2931998720) failed (error code=12)
*** error: can't allocate region
*** set a breakpoint in malloc_error_break to debug...
Deltamac,
Thanks for all of your assistance. I've followed all of the steps above. the disk was good, I ran the maintenance as well. I still get the original error in Terminal and some apps freeze up resulting in a manual re-boot. I think the only thing left is adding some RAM. Thanks again!
The quirky issues:
When I attempt to log out it removes all of the icons but freezes at the wallpaper. I would manually power off and it would take forever to boot back to the login screen (I have a few extra accounts for the kids). Also, going into and out of screensaver it freezes and I...
Deltamac, thanks for the quick reply.
Just to be sure, I rebooted and only opened Terminal and found the following again:
login(180) malloc: *** mmap(size=2931998720) failed (error code=12)
*** error: can't allocate region
*** set a breakpoint in malloc_error_break to debug
I don"t...
mac mini
10.5.8
1 GB 667 Mhz DDR2 SDRAM
Hello all,
I opened Terminal today and the following message popped up about a hundred times:
login(4687) malloc: *** mmap(size=2931998720) failed (error code=12)
*** error: can't allocate region
*** set a breakpoint in malloc_error_break to...