empty print file

D

dozonoff

Registered
I am unable to print because print center says I have an "empty print file." This problem started happening after choking my HP Laserwriter 1200N with trying to print a webpage. No amount of rebooting, deleting/adding printers, etc. works. Now under 10.3.1 same problem. Any ideas?
 
What driver version are you using? You should have 3.0a. If not go to the HP web site>support and drivers. Select you printer model and OS X. It will bring you to a direct download.

Then empty your print center and install the driver. You should also repair permissions with Disk Utility in your utility folder. Click on verify, then repair.
 
Cheryl said:
What driver version are you using? You should have 3.0a. If not go to the HP web site>support and drivers. Select you printer model and OS X. It will bring you to a direct download.

Then empty your print center and install the driver. You should also repair permissions with Disk Utility in your utility folder. Click on verify, then repair.
Click to expand...

thanks for the info. I had done most of that. I also powercycled the hpjectdirect interface module with no effect, but after installing 10.3 powercycling that seemed to do the trick. go figure. anyway, thanks for the advice.
 
You must log in or register to reply here.
Back
Top