iSync I can't sync.

[Caillou]

I can't iSync my new Treo 600 with iApps.

I did go through the listed procedures on PalmOne and Apple KB (have the latest system 10.3.8, installed iSync conduit 1.2, make sure HotSync is enabled in HotSync Manager, that the iSync conduit is turned on too).

When I sync, HotSync Manager starts up all right, calls up iSync, but then iSync does not see my device. And I can't add it either. Just does not see it.

Funny (NOT SO in fact), if I try to re-install iSync (as proposed on Apple KB), I am told that I can't do it because PalmDesktop v4+ is needed. Well it is installed (the Treo version v4.1). I get the same message after re-installing Palm Desktop v4.1 for Treo.

PalmOne help or user forum has turned out with nothing so far. BTW, the syncing procedures works fine with PalmDesktop. But I want my iApps !

Ideas?
Thanks.
C

 

[Cheryl]

Go to your home folder>Library>Preferences. Trash the com.apple.isync.plist file. Empty the trash. Now give it a try.

 

[Notaclone]

I'm in the same boat - DT4.1 works fine with my Clie. iSync works fine with iPid and .Mac. I installed the Apple Conduit, set Hot Sync to use it. It Launches iSync (no palm device shows) and tries v.e.r.y..s.l.o.w.l.y to connect to palm and then gives up.
Log says:
Loading “Apple”
Conduit “iSync Conduit” version 3.0.0
Sync type is Fast
iSync Conduit starting 3/23/05 6:47:41 PM
Timeout waiting for Sync Engine, exiting 3/23/05 6:53:58 PM
iSync Conduit synchronization failed
“iSync Conduit” failed (error = #-2)
I tried deleting the prefs file you mentioned, but it didn't address my own issue. Hope it worked for Caillou!