Went away for the weekend, switched the electricity off, when I came back and plugged it all back in the airport, didn't function, the right light on the LED went to Amber and that was that.
I tried hard resets, where the centre light went amber and I could then see the airport via an ethernet cable. However on configuring it, it would upload the software, all the lights would flash nicely and then 90% through the restart bar, it would again resort to only the right LED being Amber, there is no flashing, it is just on.
After that of course it doesn't show up in Airport config, only after yet another hard reset, will it, but again the process just repeats itself to frustration.
Any ideas?
Thanks in advance
I tried hard resets, where the centre light went amber and I could then see the airport via an ethernet cable. However on configuring it, it would upload the software, all the lights would flash nicely and then 90% through the restart bar, it would again resort to only the right LED being Amber, there is no flashing, it is just on.
After that of course it doesn't show up in Airport config, only after yet another hard reset, will it, but again the process just repeats itself to frustration.
Any ideas?
Thanks in advance