I have an image made that is Tiger 10.4.2 and it's been put into a .dmg image file for use with ASR. When I install a certain 2 machines on the floor, after the install, the 30gig HDD's read that they are only 6.61gig's large and after the image is done installing, there is only 400k left on the drive?!?!?!
Any of you guys run across this? The machines imaged are Emac's and they have 30gig HDD's in them. And they've been working fine for some time, up until I put the new Tiger image on them.
This same tiger image works fine on another 120'ish computers....
Any idea's or advice is appreciated..
Thanks,
Scott
Any of you guys run across this? The machines imaged are Emac's and they have 30gig HDD's in them. And they've been working fine for some time, up until I put the new Tiger image on them.
This same tiger image works fine on another 120'ish computers....
Any idea's or advice is appreciated..
Thanks,
Scott