Pioneer DVR-111D

T

techmanohio

Registered
I placed a Pioneer DVR-111D into an eMac (internally).

I am getting a message in system profiler saying that no drive is not connected.

I have checked the IDE cable connections and power connections and they are ok.

The jumper is set to slave because when it was on master, the CD-rom drawer kept opening when the machine was started up.

Is there a third-party software that can help with this. I have read quite a few people able to place this drive into an eMac and it worked fine.

Any suggestions?

Thank you.
 
Check you cable connections, it should be recognized. Also you might want to set the drive too cable select. Good Luck.
 
You must log in or register to reply here.
Back
Top