serial connection dropping under Parallels

F

ferretman

Registered
I am running Windows XP professional through parallels. I have connected our telephone system operators console in thw windows software via a serial connector (I am using a USB to serial convertor cable). Initially it works however after a time the serial connection to the phone system / hardware drops.

I have tried disabling the power save / energy features in both MAC OSX and Windows

Any ideas ?

thanks

Ferretman
 
check on the serial device setup. perhaps something in hardware handshake? Too late/early at night/morning to write about what could be causing it to work, then fail. I'd think it if required handshake, and it was off, it'd stop or not work at all.
 
You must log in or register to reply here.
Back
Top